|
[Sponsors] |
September 20, 2013, 13:12 |
The dsmcFieldsCalc doesn't calculate U and T
|
#1 |
New Member
Javad
Join Date: Aug 2013
Location: Iran
Posts: 8
Rep Power: 12 |
Hello dear foamers
I'm a Master student. I'm going to use dsmcFoam in my thesis. But unfortunately I'm a beginner in both linux and OpenFOAM utilization. Anyway, I made up my mind to start with tutorials of dsmcFoam. And then I found out dsmcFieldsCalc doesn't calculate U and T in all of cases in tutorial. This is my problem. I don't know how I should solve this problem. By the way I'm using OpenFOAM 2.2.1 and Ubuntu 13.04. please help me. I need your help very much. Thank you very much in advance. Best regards |
|
February 7, 2014, 23:28 |
|
#2 |
New Member
reji
Join Date: Nov 2011
Posts: 8
Rep Power: 14 |
Macroscopic results(U,T,P etc) are calculated using ensemble averaging.
By running "wedge15Ma5" you will get "Umean, OverallT, p etc. " |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
calculate species reaction rate | Anna_p | FLUENT | 2 | July 1, 2013 13:10 |
How to calculate the vehicle front/rear lift forces | zhang6425532 | Main CFD Forum | 6 | May 19, 2013 13:50 |
calculate Nu number | Diana.N | FLUENT | 3 | February 27, 2012 13:40 |
calculate values for eps and k from Re or u????? | sbar | OpenFOAM Pre-Processing | 5 | August 16, 2010 04:10 |
How to calculate Torque for francis turbine | manish | CFX | 4 | March 15, 2007 02:57 |