|
[Sponsors] |
Wrong results after Modifying yPlus.C & OP 1.6-ext |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 22, 2013, 07:47 |
Wrong results after Modifying yPlus.C & OP 1.6-ext
|
#1 |
Senior Member
Sasan Ghomi
Join Date: Sep 2012
Location: Denmark
Posts: 292
Rep Power: 14 |
Hi Foamers ,
I am using OP 1.6-ext . I understood yPlusRAS have a bug and Actually it calculates Y* instead of Y+ . So I searched in the forums and I didn't find any correct yPlus.C for 1.6-ext . {there was some codes for standard versions}. I modified the yPlus.C for 1.6-ext and after compiling I checked this utility for a case but unfortunately I got zero values for Y+ everywhere in all times. I attached this code . Please anybody help me for finding the problem in this code . I appreciate any help from you. Thanks and best regards, Sasan. P.S. I only changed compressible and incompressible parts and I didn't change two phase part . |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM - Validation of Results | Ahmed | OpenFOAM Running, Solving & CFD | 10 | May 13, 2018 18:28 |
k-omega-SST model (OF 1.6) - turbulent flat plate | cboss | OpenFOAM Running, Solving & CFD | 25 | August 9, 2016 09:53 |
BuoyantBoussinesqSimpleFoam and axial-symmetric results wrong mass flow | Thomas Baumann | OpenFOAM | 6 | December 21, 2009 10:31 |
why dynamic mesh method give wrong results? | weiyang1980 | Main CFD Forum | 0 | September 22, 2009 21:06 |
[OpenFOAM] 'integrate variables' filter on a polyhedral mesh gives wrong results... | jbf | ParaView | 0 | September 4, 2009 04:08 |