|
[Sponsors] |
July 24, 2009, 04:50 |
define cutting plane - parallel running
|
#1 |
Member
Julien Schaguene
Join Date: Apr 2009
Location: France
Posts: 55
Rep Power: 17 |
Hi,
I'm looking for a solution to define a cutting plane for parallel running. My domain is a U pipe, with an inlet lenght different from the outlet one. Looks like that: inlet...... xxxxxx .................... x .................... x outlet xxxxxxxxx The problem is that methods simple/metis/herarchical do not cut it at the middle of the U turn, so the interface is not optimal. I could eventually use a manual method, but don't have an example of implementation. Is there another solution? Regards Julien |
|
Tags |
cutting plane, parallel |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
RSH problem for parallel running in CFX | Nicola | CFX | 5 | June 18, 2012 18:31 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
Running in parallel | s.sivakumar | OpenFOAM Running, Solving & CFD | 3 | July 4, 2009 00:37 |
Getting error while running on parallel Mode | velan | OpenFOAM Running, Solving & CFD | 8 | May 10, 2009 03:26 |
Problems on running cfx in parallel | Nan | CFX | 1 | March 29, 2006 04:10 |