|
[Sponsors] |
Moving contact line on solid object, OpenFoam |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 25, 2014, 11:20 |
Moving contact line on solid object, OpenFoam
|
#1 |
Member
Join Date: Feb 2014
Posts: 34
Rep Power: 12 |
Hi All,
I don't know too much about OpenFoam and I need to ask a general question. I know OpenFoam can solve multiphase problems, the problem under my consideration is a moving solid object through a fluid-fluid interface. I need to define the contact angle when there is a fluid-fluid-solid contact line an this contact line may be moving as the solid is moving. I just want to know if OpenFoam can solve this problem before making any decisions to learn using it. I tried this problem in Gerris but turns out Gerris doesn't solve this kind of problem. Thank you for all your suggestions! Best, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 05:42 |
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 08:48 |
OpenFOAM15 installables are incomplete problem with paraFoam | tryingof | OpenFOAM Bugs | 17 | December 7, 2008 04:41 |
Problem of compilation OF 14Allwmake command not found | erik_d | OpenFOAM Bugs | 13 | September 13, 2008 21:45 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |