|
[Sponsors] |
[stressAnalysis] a problem about boundary condition in stressanalysis |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 8, 2011, 04:49 |
a problem about boundary condition in stressanalysis
|
#1 |
Member
chenkai
Join Date: May 2010
Location: munich
Posts: 44
Rep Power: 15 |
Hi everyone,
I want to simulate the torsion of a cylinder with OpenFOAM. (see the attached picture). But I don't know how to set the boundary condition of the outside for the cylinder, because the direction of the stress always changes. Does anyone have idea how to set this case? Is it possible to set the moment as boundary condition in OpenFOAM? Thanks a lot in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 13:55 |
Pressure Boundary Condition Problem | rbjet | CFX | 3 | July 15, 2013 21:45 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 00:00 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |