|
[Sponsors] |
March 13, 2011, 16:13 |
Problem with metis decomposition
|
#1 |
Senior Member
Tarak
Join Date: Aug 2010
Location: State College, PA
Posts: 111
Rep Power: 15 |
Hii,
I am simulating the turbulent flow over a circular cylinder using 32/64 processors. When I'm running in serial, it is running perfectly. But as soon as I use metis to decompose the domain, the code simply stops after 2/3 time steps. Again when I switch to simple decomposition, everything is fine. Please let me know the probable cause for this. Thanks, Tarak |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
Incoherent problem table in hollow-fiber spinning | Gianni | FLUENT | 0 | April 5, 2008 10:33 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Node numbering at interface in MeTiS. | mehul | CFX | 0 | December 19, 2006 10:22 |