|
[Sponsors] |
April 1, 2016, 07:38 |
Paticles visulization problem
|
#1 |
New Member
Gul niamat
Join Date: Mar 2016
Posts: 4
Rep Power: 10 |
Hi every one..!
i am new user of paraview,actually i am simulating a mixer that contain two different glass particles in LIGGGHTS ,one has dai 2mm and second has dia of 3mm.My problem is when i open the simulations files form LIGGGHTS in paraview it shows particles in points form with same size and with spacing as well. i want to see particles with original size and with no space in between them. I got the idea of "PointSprite plug-in" in ParaView from some where.I made changes like this { In Object Inspector - Display" select "Scale by - radius", then push the button "Edit Radius Transfer Function" and finally select "Proportionnal" instead "Use scalar range".} but the problem is that when once i select the files from LIGGGHTS and push the apply button and then i make these changes then the apply button is not available to apply again ,i mean i can't apply the setting of PointSprite plug-in. So please any body who know about this ,kindly guide me .I am suffering for last two months due to this problem. I also used the idea of Glyph in this way In Glyph properties: Scalars radius Glyph type Sphere Radius 1 Scale Mode Scalar Set Scale Factor 1 now i don't know what to write in "Max # of points box" ???? Is this is the total number of particles ?? when i considered this as total # of particles ,so in my case there are 50000 particles ,when i put 40000 or 50000 in given box its stop works. please need help in this regards too. Thanks |
|
April 1, 2016, 15:04 |
problem with PointSprite plug-in
|
#2 |
New Member
Gul niamat
Join Date: Mar 2016
Posts: 4
Rep Power: 10 |
I tried to use PointSprite plug-in ,but it just quiet (exit) the paraview. Error shown in terminal is "Segmentation Fault (core dumped)".I searched about this error and i found that it need to install nam _1.14 ect.I tried to install nam-1.15-10_i386.deb and nam-1.14_amd64.deb but it failed, i mean installation failed ,i am using paraview_4.1.0-Linux-32bit. could you help me what i do now??? which package i do install now for this error ??
Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] engineFoam new mesh problem | ayhan515 | OpenFOAM Meshing & Mesh Conversion | 5 | August 10, 2015 08:45 |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |