|
[Sponsors] |
May 30, 2003, 14:37 |
About the pressure coefficients
|
#1 |
Guest
Posts: n/a
|
Hi all, For the pressure coefficients
Pressure Coefficient The mass flow through the opening is: M" = C * (Pext - Pint) when different values are used the CFD computation will definetely different,say,why not use 2 or 3 instead of 1 for the coefficients? if pressure BC is used for the outlets the mass flow rate is not known beforehand how do you determine this pressure coefficient?when 1 is used what happens then? does that mean the mass=1.0(Pext-Pint) always? would somebody gives me some details about how to determine the coefficents for pressure boundary conditions? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure coefficients | antonio_ing | OpenFOAM Running, Solving & CFD | 8 | August 8, 2012 07:22 |
Specifying Wind Pressure Coefficients | NK | FLUENT | 0 | January 30, 2009 07:32 |
Pressure coefficients | antonio_ing | OpenFOAM Post-Processing | 1 | December 29, 2008 22:01 |
Problems with pressure coefficients | Khoa Kim | FLUENT | 2 | August 26, 2008 08:02 |
rms of pressure coefficients | kbutler | FLUENT | 0 | August 27, 2007 17:20 |