CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums

Search Results

Register Blogs Community New Posts Updated Threads Search

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: Fernando R.
Forum: CFX March 14, 2014, 15:56
Replies: 23
Views: 15,529
Posted By Fernando R.
I was testing the results with this method and...

I was testing the results with this method and noticed that the value of torque obtained with the monitor point differed a bit from the value acquired by using the 'Function Calculator' (in...
Forum: CFX March 14, 2014, 12:35
Replies: 23
Views: 15,529
Posted By Fernando R.
It works now. Thank you very much :) The unit...

It works now. Thank you very much :)
The unit of the torque measured is relative to the solution units, right?
Forum: CFX March 13, 2014, 15:16
Replies: 23
Views: 15,529
Posted By Fernando R.
Is it what I should do? I type "torque_z()@pa",...

Is it what I should do? I type "torque_z()@pa", press enter and apply and the field doesn't go empty. But, if I press ok, then open again the monitor point, the output variable goes automatically to...
Forum: CFX March 13, 2014, 14:18
Replies: 23
Views: 15,529
Posted By Fernando R.
I will try it.

I will try it.
Forum: CFX March 13, 2014, 13:43
Replies: 23
Views: 15,529
Posted By Fernando R.
Torque over time. I'm simulating a vertical axis...

Torque over time. I'm simulating a vertical axis wind turbine and I need in the torque vs angular position curve.
Forum: CFX March 13, 2014, 13:19
Replies: 23
Views: 15,529
Posted By Fernando R.
Hello. I can't set a torque monitor point. When I...

Hello. I can't set a torque monitor point. When I created it, torque wasn't in the output variable list. I've typed "torque_z()@pa" ("pa" was the name of the surface I've wanted to evaluate the...
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -4. The time now is 05:13.

Contact Us - CFD Online - Privacy Statement - Top