Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: geod

Forum: ANSYS Meshing & Geometry

November 24, 2014, 10:20

Replies: 10

[ICEM] Concentric Tubes Blocking & Meshing

Views: 2,022

Posted By geod

Excuse my amateurness... In regards to the...

Excuse my amateurness... In regards to the complicated version picture I posted, I don't know where the unnecessary blocks came from. All I did was create a block, create the O-grid split the blocks...

Forum: ANSYS Meshing & Geometry

November 19, 2014, 10:02

Replies: 10

[ICEM] Concentric Tubes Blocking & Meshing

Views: 2,022

Posted By geod

Thanks for the photos, I have attempted a similar...

Thanks for the photos, I have attempted a similar case to yours however when I do this my inner pipe ends up taking the inner flow, the outer flow takes it's own section and the inner pipe section,...

Forum: ANSYS Meshing & Geometry

November 16, 2014, 11:40

Replies: 10

[ICEM] Concentric Tubes Blocking & Meshing

Views: 2,022

Posted By geod

35183 So I've managed to a get a pre mesh...

35183

So I've managed to a get a pre mesh looking like this.. But can't figure out why the Outerflow is condensing to one side, same with the inner pipe. Any ideas how to clean it up?

Forum: ANSYS Meshing & Geometry

November 15, 2014, 11:19

Replies: 10

[ICEM] Concentric Tubes Blocking & Meshing

Views: 2,022

Posted By geod

Hi Davide, First of all, thanks for your...

Hi Davide,

First of all, thanks for your interest and help. I tried out the steps that you suggested (as close as I could, I think I did ok), here is a couple photos of the pre-mesh along with...

Forum: ANSYS Meshing & Geometry

November 13, 2014, 10:15

Replies: 10

[ICEM] Concentric Tubes Blocking & Meshing

Views: 2,022

Posted By geod

Couple photos of geometry for reference.. just a...

Couple photos of geometry for reference.. just a simple tube within a tube.

35085

35086

Forum: ANSYS Meshing & Geometry

November 12, 2014, 11:37

Replies: 10

[ICEM] Concentric Tubes Blocking & Meshing

Views: 2,022

Posted By geod

Concentric Tubes Blocking & Meshing

Hi all,

I am currently working on a project where I am required to simulate the heat exchangement from one fluid to another in concentric pipes. A hot fluid will pass through the inner tube, with...

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -4. The time now is 03:45.