Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: Dosin

Forum: OpenFOAM Running, Solving & CFD

July 11, 2016, 04:04

Replies: 8

Simulate cyclone separators by MPPICFoam: large errors when scaled down to mm

Views: 1,372

Posted By Dosin

Hey Ali, 1. No, u can't use 2D in OpenFOAm....

Hey Ali,

1. No, u can't use 2D in OpenFOAm. I meant you have to consider the points of your cube so that they're fitted with the outer surface of your cyclone configuration. For instance if the...

Forum: OpenFOAM Running, Solving & CFD

July 8, 2016, 10:56

Replies: 8

Simulate cyclone separators by MPPICFoam: large errors when scaled down to mm

Views: 1,372

Posted By Dosin

Hey Ali, when u want to use blockMesh you should...

Hey Ali, when u want to use blockMesh you should consider this fact that the planes of your cube should be fitted with the surface of the cyclone....it's too important for this simulation.
The...

Forum: OpenFOAM Running, Solving & CFD

February 9, 2016, 11:31

Replies: 8

Simulate cyclone separators by MPPICFoam: large errors when scaled down to mm

Views: 1,372

Posted By Dosin

Simulate cyclone separators by MPPICFoam: large errors when scaled down to mm

Dear All,

I want to simulate cyclone separators by MPPICFoam. For that, I draw a cyclone configuration in Catia and then by applying snappyHexMesh, the grids(meshes) were produced. When I used...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 16:41.