Search Results

Showing results 1 to 2 of 2
Search took 0.00 seconds. Search: Posts Made By: Onurozcan

Forum: ANSYS Meshing & Geometry

December 10, 2015, 08:01

Replies: 2

[ANSYS Meshing] Seperated two surface inflation mesh ( boundary layer)

Views: 1,442

Posted By Onurozcan

Hi hwet, Third photo is to show bottom part...

Hi hwet,

Third photo is to show bottom part of first photo,that is plenum.

That plenum is only extruded cat part.But on top of plenum is drawn a sketch in cat part(defined as named selection...

Forum: ANSYS Meshing & Geometry

December 7, 2015, 17:08

Replies: 2

[ANSYS Meshing] Seperated two surface inflation mesh ( boundary layer)

Views: 1,442

Posted By Onurozcan

Seperated two surface inflation mesh ( boundary layer)

Hi,

This project is consist of tubes(flow through air) and waste air ( outer region).Accordingly y+ and boundry layer thickness are to be used.(shown below links)

The problem I have run across...

Showing results 1 to 2 of 2

Forum Jump

All times are GMT -4. The time now is 08:33.