Search Results

Showing results 1 to 2 of 2
Search took 0.00 seconds. Search: Posts Made By: Will Anderson

Forum: ANSYS Meshing & Geometry

February 24, 2011, 09:31

Replies: 8

[ICEM] Meshing a centrifugal compressor impeller

Views: 5,816

Posted By Will Anderson

Meshing the single channel with an unstructured...

Meshing the single channel with an unstructured mesh is no problem. I did it by isolating the interior faces of the rotor blades, creating a separation line which runs down the middle of a rotor...

Forum: ANSYS Meshing & Geometry

February 23, 2011, 12:51

Replies: 8

[ICEM] Meshing a centrifugal compressor impeller

Views: 5,816

Posted By Will Anderson

Please post pictures, screenshots, etc. I...

Please post pictures, screenshots, etc.

I recently meshed a centrifugal compressor, at the beginning I was using periodic boundaries, but I eventually went with a full 360 domain as my flow was...

Showing results 1 to 2 of 2

Forum Jump

All times are GMT -4. The time now is 13:05.