Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: wyldckat

Forum: ParaView

August 20, 2015, 15:46

Replies: 7

[OpenFOAM] Cut/Clip cylinder instead of sphere/plane?

Views: 7,975

Posted By wyldckat

Thanks to this thread:...

Thanks to this thread: http://www.cfd-online.com/Forums/paraview/155354-clip-filter-type-cylinder.html - here are the revised instructions for ParaView 4.1.0:

Apply the "Programmable Filter" to...

Forum: ParaView

December 25, 2013, 11:49

Replies: 7

[OpenFOAM] Cut/Clip cylinder instead of sphere/plane?

Views: 7,975

Posted By wyldckat

Greetings Zhiyuan, That's very strange....

Greetings Zhiyuan,

That's very strange. What was the exact command line you used to export the case to VTK?

And the reported Python code should work on any Operating System that can run...

Forum: ParaView

October 19, 2013, 13:09

Replies: 7

[OpenFOAM] Cut/Clip cylinder instead of sphere/plane?

Views: 7,975

Posted By wyldckat

Greetings Nisha, Very good point! Back when...

Greetings Nisha,

Very good point! Back when I figured out how to use the "Cylinder" for slicing the results, I didn't properly read that this thread was about clipping and not slicing!

OK,...

Forum: ParaView

May 18, 2013, 14:54

Replies: 7

[OpenFOAM] Cut/Clip cylinder instead of sphere/plane?

Views: 7,975

Posted By wyldckat

Sorry for digging this thread from so far in the...

Sorry for digging this thread from so far in the past.
But since this shows up in the top Google search results when looking for this question, I'll leave a note to the recent solution:...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 15:20.