Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: holzmichel

Forum: OpenFOAM

September 16, 2009, 03:57

Replies: 11

Two regions, problem ?

Views: 1,980

Posted By holzmichel

well my case do not have an inlet and outlet. I...

well my case do not have an inlet and outlet. I want to transport the fluid in the case with the rotor. When I set dt very small like 1*10-7 or higher like 5*10-3 it makes no difference of the...

Forum: OpenFOAM

September 14, 2009, 05:26

Replies: 11

Two regions, problem ?

Views: 1,980

Posted By holzmichel

Hello Steve, thanks for your help. I tried...

Hello Steve,

thanks for your help. I tried your suggestion but the same error is given.
Maybe some other reasons for this problem.

Regards
Michél

Forum: OpenFOAM

September 3, 2009, 10:38

Replies: 11

Two regions, problem ?

Views: 1,980

Posted By holzmichel

here is the case. sets(insideZone / outsideZone),...

here is the case. sets(insideZone / outsideZone), points, faces, etc. in constant I deleted because of the size. I also attached the checkMesh log in the archive. Maybe someone find out what is...

Forum: OpenFOAM

September 3, 2009, 08:54

Replies: 11

Two regions, problem ?

Views: 1,980

Posted By holzmichel

hi Christof, thank you first for your very...

hi Christof,

thank you first for your very fast reply :)
I looked a few times in that case to find out what I am doing wrong. I followed the steps like openfoamwiki describes about the ggi. I...

Forum: OpenFOAM

September 3, 2009, 08:00

Replies: 11

Two regions, problem ?

Views: 1,980

Posted By holzmichel

Hello all, I have the same Problem like...

Hello all,

I have the same Problem like Dipling.
I merged my Meshes (rotor and stator) to use the interDyMFoam solver. When I run checkMesh I still have two faces which are not connected. Is it...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 05:08.