Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: T_Portolon

Forum: ANSYS Meshing & Geometry

August 29, 2011, 20:31

Replies: 10

[ICEM] ICEM 12.1 - car meshing

Views: 2,296

Posted By T_Portolon

Case and data transfering

Hi Simon

Thanks for helping with ICEM. Do you work with Fluent? I've been using a
8-processor machine to run the simulations. When I try to open those files in my machine (4-processor), it...

Forum: ANSYS Meshing & Geometry

August 22, 2011, 17:53

Replies: 10

[ICEM] ICEM 12.1 - car meshing

Views: 2,296

Posted By T_Portolon

Simon, The surfaces were meshed before...

Simon,

The surfaces were meshed before delaunay volume meshing. For first, I selected "mesh internal domains", and meshed the volume. I think I had a problem with the geometry. Then, I saved it in...

Forum: ANSYS Meshing & Geometry

August 18, 2011, 16:39

Replies: 10

[ICEM] ICEM 12.1 - car meshing

Views: 2,296

Posted By T_Portolon

Delaunay for tetras

Hi Simon,

I made some volume meshes with octree, and it was ok. Now I'm trying to use Delaunay, to reduce the number of cells (around 3-4 million). I tried to use densities around the car body,...

Forum: ANSYS Meshing & Geometry

July 26, 2011, 19:57

Replies: 10

[ICEM] ICEM 12.1 - car meshing

Views: 2,296

Posted By T_Portolon

Direct volume meshing

Simon,

I made the mesh as you said, and it was ok.
Now, I gonna try to use a density around the model, to refine the mesh a little bit.
I used to work with ICEM as I did it with Gambit (meshing...

Forum: ANSYS Meshing & Geometry

July 25, 2011, 18:30

Replies: 10

[ICEM] ICEM 12.1 - car meshing

Views: 2,296

Posted By T_Portolon

Curve & surface meshing (and one more question)

Simon,

Thanks for the help! Actually, I'm following these steps to obtain a surface mesh:
1. mesh the curves (width may vary, depending on the location)
2. mesh the surfaces (applying size in...

Forum: ANSYS Meshing & Geometry

July 23, 2011, 16:12

Replies: 10

[ICEM] ICEM 12.1 - car meshing

Views: 2,296

Posted By T_Portolon

ICEM 12.1 - car meshing

Hi everyone,

I'm facing a little trouble in surface meshing with ICEM 12.1. Using the mesh type "all tri" and mesh method "patch dependent", I have had as result, that the boundaries of the...

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -4. The time now is 08:00.