Search Results

Showing results 1 to 2 of 2
Search took 0.00 seconds. Search: Posts Made By: Anorky

Forum: ANSYS Meshing & Geometry

November 30, 2009, 07:10

Replies: 3

[ICEM] Mesh lines and points

Views: 3,862

Posted By Anorky

Hi Simon, Previously I didn't associate alle...

Hi Simon,

Previously I didn't associate alle edges to curves of the geometry. But than I sometimes ended up having a mesh that didn't follow the geometry at f.e. sharp edges and so on as you said....

Forum: ANSYS Meshing & Geometry

November 25, 2009, 04:00

Replies: 3

[ICEM] Mesh lines and points

Views: 3,862

Posted By Anorky

Mesh lines and points

Hi everyone,

I have a short question.
I am making a fully hexagonal mesh in ICEM. Normally when you mesh the geometry, turn off the geomerty and check the lines and points of the mesh, these...

Showing results 1 to 2 of 2

Forum Jump

All times are GMT -4. The time now is 02:44.