Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: stefanke

Forum: OpenFOAM Meshing & Mesh Conversion

June 19, 2006, 09:03

Replies: 58

[Commercial meshers] Harpoon to Foam

Views: 9,652

Posted By stefanke

the harpoon export works fine

the harpoon export works fine with OF1.2 and OF1.3 but as Eugene has already mentioned one have to convert the boundary file (ASCII) from the dos to unix format!

I think the following 2 options...

Forum: OpenFOAM Meshing & Mesh Conversion

April 21, 2006, 06:08

Replies: 58

[Commercial meshers] Harpoon to Foam

Views: 9,652

Posted By stefanke

I have tested the new Harpoon

I have tested the new Harpoon release and there was always the same problem with OF 1.3 (same failure as described above). With OF 1.2 all works fine.

So it has definitly something to do with...

Forum: OpenFOAM Meshing & Mesh Conversion

April 21, 2006, 03:20

Replies: 58

[Commercial meshers] Harpoon to Foam

Views: 9,652

Posted By stefanke

Harpoon is not ready for OpenF

Harpoon is not ready for OpenFoam 1.3. But with OpenFoam 1.2 it should work!

Forum: OpenFOAM Meshing & Mesh Conversion

April 13, 2006, 18:10

Replies: 58

[Commercial meshers] Harpoon to Foam

Views: 9,652

Posted By stefanke

Just start the executable: "ha

Just start the executable: "harpoon -foam"

Forum: OpenFOAM Meshing & Mesh Conversion

March 8, 2006, 07:07

Replies: 58

[Commercial meshers] Harpoon to Foam

Views: 9,652

Posted By stefanke

I agree with Mattijs, this

I agree with Mattijs,

this is the information I get yesterday from Richard Bardwell:

We have done some work on an export to OpenFOAM. We can only justify
completeing the export if we...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 02:03.