CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums

Search Results

Register Blogs Community New Posts Updated Threads Search

Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: Aeronautics El. K.
Forum: Pointwise & Gridgen August 3, 2014, 20:11
Replies: 12
Views: 4,196
Posted By Aeronautics El. K.
Hi Payam! Thanks for your detailed...

Hi Payam!

Thanks for your detailed explanation and the example you set up!
The truth is that I hadn't really understood how the trim by surface and trim by curve options work because after...
Forum: Pointwise & Gridgen July 13, 2014, 22:17
Replies: 12
Views: 4,196
Posted By Aeronautics El. K.
You're not interrupting anything of course!...

You're not interrupting anything of course! Thanks for your reply.

Trimming the two surfaces was the first thing I did as it also seemed to be the most reasonable step. However, the inside area...
Forum: Pointwise & Gridgen July 13, 2014, 18:14
Replies: 12
Views: 4,196
Posted By Aeronautics El. K.
Hello! I'm sorry I didn't reply sooner but I...

Hello!

I'm sorry I didn't reply sooner but I started over meshing the whole geometry.

Chris, your advice was invaluable. I think I got the hang of it! Thank you!

There is a point though that...
Forum: Pointwise & Gridgen July 10, 2014, 09:34
Replies: 12
Views: 4,196
Posted By Aeronautics El. K.
Hi Chris! I can confirm that I followed...

Hi Chris!

I can confirm that I followed those steps so you understood correctly.
I think I get it and I'll try it right now. So, I start over the engine-pylon following your suggestions. There...
Forum: Pointwise & Gridgen July 9, 2014, 14:57
Replies: 12
Views: 4,196
Posted By Aeronautics El. K.
Hi Chris!! Thanks for your help. I tried...

Hi Chris!!

Thanks for your help. I tried what you suggested and it worked. You saved the day with this one!

I do have another problem though again with the nacelle and the pylon. More...
Forum: Pointwise & Gridgen July 8, 2014, 16:20
Replies: 12
Views: 4,196
Posted By Aeronautics El. K.
Unstructured surface mesh

Hello all!

I am trying to mesh an aircraft geometry and I have a problem with the surface mesh on two surfaces. Those surfaces are the left and right side of the engine's pylon.

I have...
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -4. The time now is 07:32.