Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: atmcfd

Forum: OpenFOAM Meshing & Mesh Conversion

November 1, 2012, 20:51

Replies: 11

[Commercial meshers] Mesh conversion from Tecplot format - help

Views: 7,611

Posted By atmcfd

Bruno, Sorry for getting back late. I just...

Bruno,

Sorry for getting back late. I just wanted to thank you for your help and post my solution here....
I had finally managed to get the mesh into OF. As you said, the high aspect ratio was...

Forum: OpenFOAM Meshing & Mesh Conversion

October 14, 2012, 16:10

Replies: 11

[Commercial meshers] Mesh conversion from Tecplot format - help

Views: 7,611

Posted By atmcfd

Hi Bruno, I ran checkMesh and this is the...

Hi Bruno,

I ran checkMesh and this is the output I get

// * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * //
Create time

Create polyMesh for time = 0

Time = 0

Forum: OpenFOAM Meshing & Mesh Conversion

October 12, 2012, 01:55

Replies: 11

[Commercial meshers] Mesh conversion from Tecplot format - help

Views: 7,611

Posted By atmcfd

Bruno, Thanks for the heads up. Just an...

Bruno,

Thanks for the heads up. Just an update here:

I made some changes to the datToFoam source code, in the places where the comments say that the the lines of code are meant for biconic...

Forum: OpenFOAM Meshing & Mesh Conversion

October 8, 2012, 03:16

Replies: 11

[Commercial meshers] Mesh conversion from Tecplot format - help

Views: 7,611

Posted By atmcfd

Thank you very much Bruno! I could do the...

Thank you very much Bruno!

I could do the steps and obtain the mesh - it looks good. I have some questions on this method:

1) is the blockMeshDict file containing the default points
vertices...

Forum: OpenFOAM Meshing & Mesh Conversion

October 7, 2012, 03:16

Replies: 11

[Commercial meshers] Mesh conversion from Tecplot format - help

Views: 7,611

Posted By atmcfd

dear bruno, I did tun the biconic dat file...

dear bruno,

I did tun the biconic dat file through the converter before posting in the forum... though I understood how datToFOAM works, I cannot understand how the points.tmp file had...

Forum: OpenFOAM Meshing & Mesh Conversion

October 6, 2012, 19:37

Replies: 11

[Commercial meshers] Mesh conversion from Tecplot format - help

Views: 7,611

Posted By atmcfd

Mesh conversion from Tecplot format - help

All,

I have been wanting to do a LES simulation of the NASA 2D periodic hill test case given here http://turbmodels.larc.nasa.gov/Other_LES_Data/2dhill_periodic.html
...

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -4. The time now is 12:07.