Forum: ANSYS Meshing & Geometry
June 14, 2012, 02:44
|
Replies: 19
Views: 3,538
Re
Hi dear mAx,
I checked the blades as you said and found out a problem in my Solid Works model.
Now, I'm going to improve it and then try it again in Gambit.
Thank you in advance,
Regards,...
|
Forum: ANSYS Meshing & Geometry
June 13, 2012, 04:04
|
Replies: 19
Views: 3,538
Re
Hi dear mAx,
During meshing a discontinuity occurs as showed in figure. It seems that it is as a result of existence of two virtual and aslo two real edge in a face, isn't?
What should i do?
...
|
Forum: ANSYS Meshing & Geometry
June 13, 2012, 01:30
|
Replies: 19
Views: 3,538
Re
OK, Thank you in advance!
I'll do that. :)
Regards,
Bahar
|
Forum: ANSYS Meshing & Geometry
June 13, 2012, 01:19
|
Replies: 19
Views: 3,538
Re
Hi dear mAx,
I should subtract volumes to get appropriate domain as you saw. It it possible subtracting a virtual volume from a real one? And may it cause any problem in Fluent (virtual blades)?
...
|
Forum: ANSYS Meshing & Geometry
June 12, 2012, 09:14
|
Replies: 19
Views: 3,538
|
Forum: ANSYS Meshing & Geometry
June 12, 2012, 04:09
|
Replies: 19
Views: 3,538
|
Forum: ANSYS Meshing & Geometry
June 12, 2012, 03:51
|
Replies: 19
Views: 3,538
|
Forum: ANSYS Meshing & Geometry
June 12, 2012, 03:36
|
Replies: 19
Views: 3,538
|
Forum: ANSYS Meshing & Geometry
June 12, 2012, 03:33
|
Replies: 19
Views: 3,538
|
Forum: ANSYS Meshing & Geometry
June 12, 2012, 03:16
|
Replies: 19
Views: 3,538
Re:problem with importing geometry in Gambit
Thank you dear mAx!
I'll do all this and will announce you about the result. But there is a problem, I'm using Gambit version 2.3, I can not find here what you said about cleaning tool...
|
Forum: ANSYS Meshing & Geometry
June 12, 2012, 03:01
|
Replies: 19
Views: 3,538
Re:problem with importing geometry in Gambit
Wow! Thank you so much for all this helpful points :)
If I understand correctly, you mean by deleting short edges I can merging the faces. Isn't it?
And about connecting faces 47 & 27, do you...
|
Forum: ANSYS Meshing & Geometry
June 11, 2012, 11:49
|
Replies: 19
Views: 3,538
Problem with merging edges/faces
Hello everybody,
I have a problem while importing geometry from Solid Works to Gambit.
As showed in figures, there are 3 blades that would be meshed. But every side edges of blades has broken in...
|