Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: keepfit

Forum: OpenFOAM Meshing & Mesh Conversion

September 5, 2012, 19:21

Replies: 4

[Other] Unstructured 3D quad mesher for OpenFoam ?

Views: 4,204

Posted By keepfit

thanks elvis. I did try enGrid for a while....

thanks elvis.

I did try enGrid for a while. For coarse mesh enGrid does a good job. However, for fine mesh e.g 100k-1M cells generated by enGrid, it just does not pass the checkMesh in OF: big...

Forum: OpenFOAM Meshing & Mesh Conversion

September 3, 2012, 22:52

Replies: 4

[Other] Unstructured 3D quad mesher for OpenFoam ?

Views: 4,204

Posted By keepfit

thanks for your reply. This simple example...

thanks for your reply.

This simple example is just used for testing tet meshing quality imported in OF. I know some commercial codes such as ANSYS and CUBIT are able to generate unstructured 3D...

Forum: OpenFOAM Meshing & Mesh Conversion

September 3, 2012, 14:04

Replies: 4

[Other] Unstructured 3D quad mesher for OpenFoam ?

Views: 4,204

Posted By keepfit

Unstructured 3D quad mesher for OpenFoam ?

i am new to OpenFoam. Since OF is very sensitive to mesh quality (I tried importing tet mesh into OF and it blows up very often due to bad mesh quality).

So i was wondering, is there any Open...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 13:48.