Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: flotus1

Forum: ANSYS Meshing & Geometry

July 23, 2012, 09:35

Replies: 7

[ANSYS Meshing] Unwanted bias while meshing a tube with sweep and inflation

Views: 7,046

Posted By flotus1

You can do it this way, but it will most...

You can do it this way, but it will most certainly result in a non-conformal interface.
Only if the pieces are merged in one part, the ansys mesher will match the nodes at the edges.

Afterwards,...

Forum: ANSYS Meshing & Geometry

July 23, 2012, 08:40

Replies: 7

[ANSYS Meshing] Unwanted bias while meshing a tube with sweep and inflation

Views: 7,046

Posted By flotus1

I wasn't aware that you use the automatic...

I wasn't aware that you use the automatic inflations.
Switch them off if you want to control the outcome of the mesh.
Use edge sizing with biasing instead.

In my opinion, there are two options...

Forum: ANSYS Meshing & Geometry

July 23, 2012, 05:42

Replies: 7

[ANSYS Meshing] Unwanted bias while meshing a tube with sweep and inflation

Views: 7,046

Posted By flotus1

First of all, you should apply a "structured...

First of all, you should apply a "structured mesh" to all the surfaces.
This will eliminate the unstructured mesh at the inlet faces.

In the second step, you could try to reset your mesh data...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 00:32.