Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: Sunxing

Forum: OpenFOAM Meshing & Mesh Conversion

September 16, 2014, 22:06

Replies: 9

[snappyHexMesh] problems using snappyHexMesh 2.1.0 on a supercomputer

Views: 4,189

Posted By Sunxing

Hi Bruno, I don't know much about the...

Hi Bruno,

I don't know much about the MPI thing. I tried the commands you offered. If I source the OF-2.1.0, then the feedback is [envision_lijun@sn02 sector_0]$ echo $FOAM_MPI
mpi...

Forum: OpenFOAM Meshing & Mesh Conversion

September 14, 2014, 21:05

Replies: 9

[snappyHexMesh] problems using snappyHexMesh 2.1.0 on a supercomputer

Views: 4,189

Posted By Sunxing

Hi Bruno, Thanks very much for your...

Hi Bruno,

Thanks very much for your patience and the full answer. Following your advise, I have tested the same case with 8 processors and it failed again. But for another case of less girds...

Forum: OpenFOAM Meshing & Mesh Conversion

September 13, 2014, 10:17

Replies: 9

[snappyHexMesh] problems using snappyHexMesh 2.1.0 on a supercomputer

Views: 4,189

Posted By Sunxing

Hi Bruno, Sorry that i offered the wrong log...

Hi Bruno,

Sorry that i offered the wrong log file. It should be:
/*---------------------------------------------------------------------------*\
| ========= | ...

Forum: OpenFOAM Meshing & Mesh Conversion

September 13, 2014, 09:17

Replies: 9

[snappyHexMesh] problems using snappyHexMesh 2.1.0 on a supercomputer

Views: 4,189

Posted By Sunxing

Hi Bruno, Thanks for your reply. I...

Hi Bruno,

Thanks for your reply. I forgot to metion that this error just happen when it was parallel processing. If i do it without parallel there is nothing wrong, while it is very time...

Forum: OpenFOAM Meshing & Mesh Conversion

September 9, 2014, 02:28

Replies: 9

[snappyHexMesh] problems using snappyHexMesh 2.1.0 on a supercomputer

Views: 4,189

Posted By Sunxing

problems using snappyHexMesh 2.1.0 on a supercomputer

Hi foamers,

I'm using snappyHexMesh on a supercomputer, but there is something wrong that I can't solve. Can anyone give me some hints?
(OpenFoam-2.1.0 and red-hat 5.3)
here is the log file for...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 13:16.