Search Results

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: Crank-Shaft

Forum: ANSYS Meshing & Geometry

June 9, 2014, 18:57

Replies: 10

[ICEM] Extracting geometry information from Plot3D File Format

Views: 7,339

Posted By Crank-Shaft

Hi Guxin, I did this a long time ago so I...

Hi Guxin,

I did this a long time ago so I don't recall all the steps in the process however, I remember that the plot3D file actually had to be imported into ICEM and had
to have the BC modified...

Forum: ANSYS Meshing & Geometry

November 30, 2012, 20:22

Replies: 10

[ICEM] Extracting geometry information from Plot3D File Format

Views: 7,339

Posted By Crank-Shaft

I finally managed to work with the Plot3D files,...

I finally managed to work with the Plot3D files, but the process used to obtain the mesh might have been mostly non-standard.

Firstly, I had to open Fluent standalone application and then import...

Forum: ANSYS Meshing & Geometry

November 15, 2012, 03:11

Replies: 10

[ICEM] Extracting geometry information from Plot3D File Format

Views: 7,339

Posted By Crank-Shaft

Tried Another Grid from a Similar source and this...

Tried Another Grid from a Similar source and this was a single block, 2D, structured, double-precision import however, I keep getting the warning message shown below. ICEM simply doesn't load or make...

Forum: ANSYS Meshing & Geometry

November 13, 2012, 20:21

Replies: 10

[ICEM] Extracting geometry information from Plot3D File Format

Views: 7,339

Posted By Crank-Shaft

Was anyone able to extract the geometry or import...

Was anyone able to extract the geometry or import the file into ICEM and Fluent?

Thanks for any suggestions you may have.

Forum: ANSYS Meshing & Geometry

November 12, 2012, 02:33

Replies: 10

[ICEM] Extracting geometry information from Plot3D File Format

Views: 7,339

Posted By Crank-Shaft

I have finally found the time to try this out and...

I have finally found the time to try this out and now I can't even import the mesh file into ICEM anymore. This is so frustrating now since I am following the exact directions given on the research...

Forum: ANSYS Meshing & Geometry

November 5, 2012, 17:01

Replies: 10

[ICEM] Extracting geometry information from Plot3D File Format

Views: 7,339

Posted By Crank-Shaft

Thanks for your response Simon. I have noticed...

Thanks for your response Simon.
I have noticed that the entire outer perimeter including the inlet, outlet, upper and the lower walls are a single entity in the model tree. This is the main problem...

Forum: ANSYS Meshing & Geometry

October 30, 2012, 18:20

Replies: 10

[ICEM] Extracting geometry information from Plot3D File Format

Views: 7,339

Posted By Crank-Shaft

Extracting geometry information from Plot3D File Format

Hello all,

I am currently attempting some preliminary studies on flow separation, vorticity and turbulence modelling. I have managed to find a well-known and widely studied geometry and modelling...

Showing results 1 to 7 of 7

Forum Jump

All times are GMT -4. The time now is 12:20.