Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: romant

Forum: OpenFOAM Meshing & Mesh Conversion

February 8, 2013, 05:04

Replies: 14

[snappyHexMesh] Orifice mesh with snappyHexMesh

Views: 2,251

Posted By romant

I am not sure if they can overlap, but I think...

I am not sure if they can overlap, but I think they should not overlap. If you cut the stl surface apart, then there should not be any overlap.

Forum: OpenFOAM Meshing & Mesh Conversion

February 8, 2013, 04:42

Replies: 14

[snappyHexMesh] Orifice mesh with snappyHexMesh

Views: 2,251

Posted By romant

I use SolidEdge and also used Salome (as...

I use SolidEdge and also used Salome (as linnemann noticed). As he also noticed, you can just have the seperate stl files in snappyHexMesh, no need to concatonate them.

What do you mean with all...

Forum: OpenFOAM Meshing & Mesh Conversion

February 8, 2013, 04:25

Replies: 14

[snappyHexMesh] Orifice mesh with snappyHexMesh

Views: 2,251

Posted By romant

I usually did this latter to have different...

I usually did this latter to have different patches (take the thing apart in blender for example) and save the parts single. However, if solidworks supports something like names stl files, the...

Forum: OpenFOAM Meshing & Mesh Conversion

January 31, 2013, 14:21

Replies: 14

[snappyHexMesh] Orifice mesh with snappyHexMesh

Views: 2,251

Posted By romant

meshing with snappy hex mesh

One good start are the meshing tutorials in OpenFOAM. They use snappyHexMesh and you can try to work with them first.

Additionally, after doing the first tries with the tutorials, try to set up...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 00:51.