Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: jgil9

Forum: OpenFOAM Meshing & Mesh Conversion

September 1, 2013, 17:50

Replies: 10

[snappyHexMesh] Cyclic BC with snappyHexMesh crashes in multiple processors

Views: 3,279

Posted By jgil9

Hi Bruno, I can't thank you enough for your...

Hi Bruno,
I can't thank you enough for your help... really! And I know you must be an extremely busy person (I respect that and try not to waste your time... I had read and tried to use cyclicAMI...

Forum: OpenFOAM Meshing & Mesh Conversion

September 1, 2013, 08:28

Replies: 10

[snappyHexMesh] Cyclic BC with snappyHexMesh crashes in multiple processors

Views: 3,279

Posted By jgil9

Hi Bruno, Thanks! Still have not been able to...

Hi Bruno,
Thanks! Still have not been able to crack this problem. Tried both suggestions but with no luck, I am attaching the case with suggestion no. 1. As per your recommendation I changed...

Forum: OpenFOAM Meshing & Mesh Conversion

September 1, 2013, 01:25

Replies: 10

[snappyHexMesh] Cyclic BC with snappyHexMesh crashes in multiple processors

Views: 3,279

Posted By jgil9

Case

Bruno,
Thanks for the tip :p, I have set up the case and ran it, but I have been getting an error in createPatch, Face 3616 specified in set is not an external face of the mesh. :confused: I...

Forum: OpenFOAM Meshing & Mesh Conversion

August 31, 2013, 04:34

Replies: 10

[snappyHexMesh] Cyclic BC with snappyHexMesh crashes in multiple processors

Views: 3,279

Posted By jgil9

Thanks!

Thanks Bruno, A couple of weeks or so after I posted the initial question I stumbled on an alternative solution. I was able to run snappy with cyclic boundaries but on a single processor and only...

Forum: OpenFOAM Meshing & Mesh Conversion

August 7, 2013, 07:11

Replies: 10

[snappyHexMesh] Cyclic BC with snappyHexMesh crashes in multiple processors

Views: 3,279

Posted By jgil9

Help with CyclicAMI

Hi Bruno,
I have been trying to Apply Cyclic or CyclicAMI boundaries to the motorBike case with no success. I a farily new to OpenFoam and for my research, I need to apply Cyclic boundaries in a...

Forum: OpenFOAM Meshing & Mesh Conversion

July 25, 2013, 09:05

Replies: 10

[snappyHexMesh] Cyclic BC with snappyHexMesh crashes in multiple processors

Views: 3,279

Posted By jgil9

Cyclic BC with snappyHexMesh crashes in multiple processors

Hi all,
I am new to Open Foam and Hope you can give me a little hand, my research requires me to model a steady state turbulent case using cyclic boundaries in parallel. Seemed to me that the case...

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -4. The time now is 08:51.