CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums

Search Results

Register Blogs Community New Posts Updated Threads Search

Showing results 1 to 8 of 8
Search took 0.00 seconds. Search: Posts Made By: maddalena
Forum: OpenFOAM Meshing & Mesh Conversion April 30, 2013, 10:06
Replies: 18
Views: 6,396
Posted By maddalena
Hello, if you are trying to use Pointwise ->...

Hello,
if you are trying to use Pointwise -> OpenFoam export for OF 2.0 or following, this will not work. Export works up to previous versions. For the newest versions, you should define your...
Forum: OpenFOAM Meshing & Mesh Conversion October 4, 2010, 13:00
Replies: 18
Views: 6,396
Posted By maddalena
Yes, of course, Alberto! I am so used to open...

Yes, of course, Alberto! I am so used to open source that sometimes I forget the good side of paying a software! :rolleyes:
Let us say that I will write to Alberto for any kind of support, and of...
Forum: OpenFOAM Meshing & Mesh Conversion October 4, 2010, 10:06
Replies: 18
Views: 6,396
Posted By maddalena
This will be great! Indeed, defining master and...

This will be great! Indeed, defining master and slave faces implicitly is not always easy, and you must create the same domain in different way until you get what you want. But, well, if you can...
Forum: OpenFOAM Meshing & Mesh Conversion October 4, 2010, 05:40
Replies: 18
Views: 6,396
Posted By maddalena
Lightbulb I believe I have the answer... The patch order...

I believe I have the answer...
The patch order (master-slave) is set by the surface domain number, which is a consequence on the domain creation. For example let us say I have the following domain:...
Forum: OpenFOAM Meshing & Mesh Conversion September 16, 2010, 02:50
Replies: 18
Views: 6,396
Posted By maddalena
Hi Rick, I was wondering if it is possible to...

Hi Rick,
I was wondering if it is possible to define the order of cyclic in Pointwise, i.e. define the master and the slave face. As I showed here...
Forum: OpenFOAM Meshing & Mesh Conversion March 3, 2010, 07:41
Replies: 18
Views: 6,396
Posted By maddalena
Red face Solved!

Ok ok... The two faces were not equals... Now it works perfectly!
And thanks to hrv, the pointwise -> OF conversion is simply great! :)
Forum: OpenFOAM Meshing & Mesh Conversion February 23, 2010, 10:44
Replies: 18
Views: 6,396
Posted By maddalena
Unhappy matching tolerance

Ok, I succeeded in creating geometrically equal faces (domains) in Pointwise and defining them as cyclic. However, when I run checkMesh (note, checkMesh and not createPatch, as a consequence that I...
Forum: OpenFOAM Meshing & Mesh Conversion February 22, 2010, 11:18
Replies: 18
Views: 6,396
Posted By maddalena
fixed?

Hello Chris,
has this lack been fixed in Pointwise? Can I create geometrically equal faces (domains) in Pointwise and export them in OpenFOAM? If the problem is still open, could I used the Fluent...
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT -4. The time now is 08:32.

Contact Us - CFD Online - Privacy Statement - Top