|
[Sponsors] |
October 27, 2003, 00:19 |
raditor flow
|
#1 |
Guest
Posts: n/a
|
Hi, Just an enquiry about how to determine the flow rate in each tube of a radiator. We have one inlet and one outlet. In these in and out there is very good mass balance, but I want to check flow accuring in each individual pipe of radiator. How to calculate that in STAR CD. Help requested.
Thanks a lot |
|
October 27, 2003, 04:28 |
Re: raditor flow
|
#2 |
Guest
Posts: n/a
|
You can select the cells belonging to one tube, load velocity components, define the cross-section of the tube by comands SPOINT <coordinates of the point in the section plane> and SNORM <coordinates of the normal to the section plane> and use INTEG CSET command.
|
|
October 27, 2003, 06:24 |
Re: raditor flow
|
#3 |
Guest
Posts: n/a
|
Thank you very much Anton
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
results for flow past flat plate normal to flow | lisa | Main CFD Forum | 2 | August 30, 2005 16:36 |
External Flow-compressible flow solver-lift/drag | Tom Brown | Main CFD Forum | 7 | December 29, 2000 13:41 |