|May 5, 2014, 04:21||
Assign temperature to boundaries
Join Date: Apr 2014
Posts: 24Rep Power: 4
I've been working with Star-CCM+ for one month now and I've started a small project to test myself. I've generated a simply Body with a Inlet,Wall and Outlet Boundary. My idea was to simulate a multiphase flow of air and liquid and to analyse the heat exchange between the hot body and the cold multiphase flow. Now I face the problem that I can't assign a temperature to the boundaries. I think that the problem i up to my Physics model but I can't figure it out.
Following Physics are set up:
-Two-Layer All y+ Wall Treatment
-Multiphase Equation of State
-Realizable K-Epsilon Two-Layer
-Reynolds- Averaged Navier-Stokes
- Volume of Fluid
Does somebody know what I have to change in my models?
Thanks in advance for your answer.
Last edited by skapetan; May 5, 2014 at 09:42.
|assign temperature, multiphase flow, star-ccm+|
|Thread||Thread Starter||Forum||Replies||Last Post|
|libOpenSMOKE||Tobi||OpenFOAM Programming & Development||507||March 4, 2016 05:30|
|Static Temperature / Opening Temperature||JulianP||CFX||6||March 23, 2013 17:03|
|Inlet won't apply UDF and has temperature at 0K!||tccruise||Fluent UDF and Scheme Programming||2||September 14, 2012 06:08|
|Highly unexpected occurence of Enforce_bounds error||Chander||CFX||9||March 8, 2012 18:16|
|Too low temperature at combustor outlet||romekr||FLUENT||2||February 6, 2012 11:02|