 |
 |
 |
|
|
|
[Sponsors] | ||||
June 29, 2010, 05:18
|
How to launch Star-CCM+
|
#1 |
|
New Member
rezki
Join Date: Jun 2010
Posts: 9
Rep Power: 15  |
Hello,
I installed recently Star-CCM+ on ubuntu 9.10 but I don't know what to make to launch a graphical interface of Star-CCM+. Please, can you help me  Regards. Rezki |
|
|
|
|
|
June 29, 2010, 07:26
|
|
#2 |
|
Senior Member
Robert
Join Date: Jun 2010
Posts: 117
Rep Power: 16 |
You need to run starccm+ in the bin directory under your installation.
If I remember correctly it gives you the absolute path to this file at the end of installation. The easiest thing is to alias it in your shell. |
|
|
|
|
|
|
June 29, 2010, 10:41
|
|
#3 |
|
New Member
rezki
Join Date: Jun 2010
Posts: 9
Rep Power: 15 |
Hello,
thank you for your help. The thing is that I don't find starccm+ in bin file Regards. Rezki |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |
| [Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
| A genearl question on STAR CCM | nstar | STAR-CCM+ | 5 | June 24, 2009 09:39 |
| error in star ccm | maurizio | Siemens | 3 | October 16, 2007 05:17 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Linear Mode
