|
[Sponsors] |
August 4, 2010, 05:01 |
Graphic errors in STAR CCM+
|
#1 |
New Member
Join Date: Aug 2010
Posts: 2
Rep Power: 0 |
Hi. My name is Mattia and I'm a student of the University of Pisa.
I'm sorry but i don't understand my problem very well and my bad English don't help me to explain you . I've a Star CCM+ v.5.04 but the residual plot and my monitor plot I've set to control the convergence didn't work very well. In fact residual plot, later about 5000 iteration, starts drawing lines randomly. it's very difficult to explain so i make some screenshots. http://img217.imageshack.us/img217/9905/immagine1an.png http://img155.imageshack.us/img155/8751/immagine2nt.png http://img713.imageshack.us/img713/9241/immagine3af.png http://img30.imageshack.us/img30/9153/immagine4kz.png http://img52.imageshack.us/img52/9716/immagine5m.png Thanks a lot for any help. Mattia |
|
August 5, 2010, 03:20 |
|
#2 |
New Member
Join Date: Jul 2010
Posts: 29
Rep Power: 15 |
hello,
it is not an error. you have to set higher value of "maximum plot samples" (monitors - default value is 5000). regards |
|
August 5, 2010, 05:07 |
|
#3 |
New Member
Join Date: Aug 2010
Posts: 2
Rep Power: 0 |
so i have to put in the "maximum plot samples" a value greater than the number of my iteration. It's correct ?
Thanks a lot for your help. Mattia |
|
August 5, 2010, 05:12 |
|
#4 |
New Member
Join Date: Jul 2010
Posts: 29
Rep Power: 15 |
.....yup:]
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 13:21 |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 02:58 |
Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |