Asigning Phases to Regions for Eularian Multiphase

bb21 · January 3, 2012, 12:21

I am currently working on Star CCM+, I am using Eularian Multiphase but I am unable to assign the two phases to specific regions, the regions box is a faint grey and can not be changed. My model is of a small tube inside a bigger tube and I want to have one phase acting in the larger tube and the other in the smaller. Is this possible with multiphase and VOF method?
Any help would be greatly appreciated

ping · January 10, 2012, 03:25

for each Region, under Physics Conditions, Initial Conditions Option, select Specify Region Values.
This overrides the global initial conditions for this region, then set the required phase ratios. Do same for the other region.

January 3, 2012, 12:21	Asigning Phases to Regions for Eularian Multiphase	#1
bb21 New Member BButler Join Date: Jan 2012 Posts: 3 Rep Power: 2	I am currently working on Star CCM+, I am using Eularian Multiphase but I am unable to assign the two phases to specific regions, the regions box is a faint grey and can not be changed. My model is of a small tube inside a bigger tube and I want to have one phase acting in the larger tube and the other in the smaller. Is this possible with multiphase and VOF method? Any help would be greatly appreciated

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Explicit method for more than two phases	sachinthakre	FLUENT	1	February 17, 2011 12:07
Multiphase Flow n phases	duderino	OpenFOAM Running, Solving & CFD	22	January 13, 2010 15:27

January 10, 2012, 03:25		#2
ping Member Ping Join Date: Mar 2009 Posts: 78 Rep Power: 5	for each Region, under Physics Conditions, Initial Conditions Option, select Specify Region Values. This overrides the global initial conditions for this region, then set the required phase ratios. Do same for the other region.