Remeshing in fluent for dynamic mesh -- CFD Online Discussion Forums

December 12, 2014, 02:59

Remeshing in fluent for dynamic mesh

rsdsaurav

Member

Join Date: Nov 2012

Location: Kuala Lumpur

Posts: 33

Rep Power: 13

I am currently doing 2 way coupling but the error message shows that negative volume is detected...it means that fluid mesh is getting deformed...so I am looking for remeshing which will be simpler...but is unable to do it..Can anyone help me in this.......Thanks in advance......

Attached Images

Error_System_Coupling.png (36.8 KB, 20 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Using Surface Mesh from ANSA for Fluent Sim	tommymoose	ANSYS Meshing & Geometry	15	March 3, 2016 17:29
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 09:38
Can't Update FLuent Setup with active Connections in Mesh	dulka90	FLUENT	8	December 9, 2013 11:36
Can anybody tell me what does fluent do using MESH MOTION?	enry	FLUENT	0	October 6, 2010 12:54
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55

All times are GMT -4. The time now is 06:32.