|July 27, 2012, 07:49||
Ansys geometry generation via Ansys Workbench
Good Morning everyone,
I'm trying to do a fluid simulation over an Eppler 423 airfoil using Ansys Workbench - Fluent. I have to open the geometry section, import my airfoil curve and generate the geometry so I can mesh it. I'm following this tutorial https://confluence.cornell.edu/displ...oil+-+Geometry.
I could generate the curve, the surface, the grid and the grid surface. But then I have to create two lines, one horizontal line dividing the grid in half and one vertical line dividing the grid in half. I can create the horizontal line but I cannot create the vertical line. When I try to generate the line by selecting the sketch and generating the curve I have the error: "Boolean operation failed".
Does anybody know how can I fix it?
|ansys workbench, boolean, geometry generation|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Can't import geometry file from Icem CFD to Ansys Workbench||Julien87||ANSYS Meshing & Geometry||1||July 19, 2011 16:50|
|ANSYS Workbench 11 backup problem,||mechanicaldesign||ANSYS||0||June 21, 2011 01:48|
|WorkBench Errors( Geometry not loading), Bad Autodyn cell template||tolu||ANSYS Meshing & Geometry||4||December 21, 2010 13:17|
|Export Heat Flux CFX -> ANSYS Workbench||Freeman||CFX||2||April 11, 2010 08:24|
|Ansys Workbench 10.0||Merkur||CFX||1||June 16, 2006 06:19|