|
[Sponsors] |
August 28, 2012, 10:27 |
Automatic meshing in Tgrid
|
#1 |
New Member
Join Date: Aug 2012
Posts: 2
Rep Power: 0 |
Hy everybody,
I use a simple journal to create a mesh, but every time I change a value (number of prism layers for instance), I can't use my journal anymore because of the "automatic naming" of the software (prism-cap-n, interior-n, ..., n is a zone number assigned by Tgrid). Is there a simple way to automaticly rename these prism-cap-n, interior-n, ..., in a journal/scheme ? I'm quite sure not to be the first to ask this question, but I can't find any answer on this forum... Thank you, Neix. |
|
Tags |
automatic naming, prism-cap, tgrid |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Automatic meshing | acoustica | ANSYS Meshing & Geometry | 1 | January 11, 2011 11:20 |
using Tgrid meshing from gambit with FIdap | philippe | FLUENT | 0 | September 30, 2008 03:50 |
meshing a wing with tgrid | sandeep varma | FLUENT | 2 | April 16, 2007 03:38 |
Tgrid meshing around cylinders in GAMBIT | Chris | FLUENT | 3 | March 5, 2003 07:43 |
TGRID & Meshing | Eric | FLUENT | 3 | February 13, 2002 10:52 |