[ICEM] how to improve mesh quality in the hydrocyclone

veerukvb · October 23, 2012, 01:59

Dear Sir,

I am Veerabhadra Rao and working as JRF in IITH. I got meshing problem in the hydrocyclone. I got fine mesh at the centre and coarse mesh towards the wall and the quality of the mesh is low. Can you suggest how to improve mesh quality in the hydrocyclone.

CFD_SIM · October 23, 2012, 02:26

Hi and welcome,

i think we need some more informations.
Did you generate a hex mesh or a tetra mesh. If you worked with a tetra mesh you can use prism at the walls.
If you are using hex mesh i would think that your spacing is wrong and suggest that you look at it a change it im neccesary. (You can check it under Pre-Mesh Params and then Edge Params).

kind regards
John

diamondx · October 23, 2012, 20:28

if you search icem, blocking , in youtube you will get a video of somebody meshing a hydrocyclone. just use tthe right key word. good luck

October 23, 2012, 01:59	how to improve mesh quality in the hydrocyclone	#1
veerukvb New Member Join Date: Oct 2012 Posts: 4 Rep Power: 2	Dear Sir, I am Veerabhadra Rao and working as JRF in IITH. I got meshing problem in the hydrocyclone. I got fine mesh at the centre and coarse mesh towards the wall and the quality of the mesh is low. Can you suggest how to improve mesh quality in the hydrocyclone.

October 23, 2012, 20:28		#3
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Canada Posts: 950 Blog Entries: 21 Rep Power: 14	if you search icem, blocking , in youtube you will get a video of somebody meshing a hydrocyclone. just use tthe right key word. good luck __________________ Regards, New to ICEM CFD, try this document --> http://goo.gl/G2gkE Ali

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
No layers in a small gap	bobburnquist	OpenFOAM Native Meshers: snappyHexMesh and Others	2	November 25, 2012 08:54
[ICEM] Tetra mesh quality before and after prism layer	Chander	ANSYS Meshing & Geometry	0	December 25, 2011 22:04
[ICEM] Negative volume error in hybrid mesh	siw	ANSYS Meshing & Geometry	0	September 4, 2010 07:43
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10

October 23, 2012, 02:26		#2
CFD_SIM Member Join Date: Oct 2012 Posts: 46 Rep Power: 2	Hi and welcome, i think we need some more informations. Did you generate a hex mesh or a tetra mesh. If you worked with a tetra mesh you can use prism at the walls. If you are using hex mesh i would think that your spacing is wrong and suggest that you look at it a change it im neccesary. (You can check it under Pre-Mesh Params and then Edge Params). kind regards John