|December 19, 2012, 11:59||
3D Geometry in Rhino
Join Date: Oct 2011
Posts: 17Rep Power: 5
I have a simple 2D geometry (square) in Rhino and want to extrude it in 3D. In 2D model I have a curve which separates two sides of the geometry (2D surface). I creat a solid from 2D surface of my geometry then I extrude the curve to get simple 3D model (say a box with a wall in the middle). when I try to mesh this 3D model in ANSYS, just one side of the wall is meshed, I want to have full mesh for both side of the wall. (see attached files)
if I assign material "BODY" manually in ANSYS to both side of the wall it works well, but I want to create it automatically by Rhinoscript then send it to mesher.
any comment would be appreciated in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem Importing Geometry ProE to CFX||fatb0y||CFX||3||January 14, 2012 20:42|
|[DesignModeler] Error while Loading a Geometry||JD944||ANSYS Meshing & Geometry||0||October 25, 2011 14:51|
|Problem meshing an imported geometry||Alicia||Open Source Meshers: Gmsh, Netgen, CGNS, ...||0||March 30, 2010 04:53|
|Simulation of Flow through Complex 3D Geometry||EmersonKB||CFX||5||July 2, 2009 08:17|
|vitual _ real||deneb||FLUENT||3||January 22, 2007 05:31|