|January 16, 2013, 11:02||
Problem with geometry (Cannot merge edges together)
Join Date: Aug 2012
Posts: 21Rep Power: 4
I have just finished constructing my model, however there are some problems with the geometry.
My model have non-manifold bodies. I have identified some of them.
But when i tried to merge the edges/faces together, the modeler said that there is no valid mergable clusters.
How can I join the 2 edges together?
Last edited by natur3; January 23, 2013 at 00:53.
|Thread||Thread Starter||Forum||Replies||Last Post|
|problem to defined the geometry in autogrid 5||windmechy||NUMECA||9||June 16, 2012 10:00|
|[DesignModeler] Import external geometry problem||Houman||ANSYS Meshing & Geometry||0||May 16, 2012 04:24|
|Problem Importing Geometry ProE to CFX||fatb0y||CFX||3||January 14, 2012 20:42|
|[ICEM] Associating two edges to one curve problem||Tom.Elson||ANSYS Meshing & Geometry||3||October 25, 2011 09:50|
|Problem when I try to write the geometry file||massimo||CD-adapco||0||January 14, 2003 05:58|