 |
 |
 |
|
|
|
[Sponsors] | ||||
February 19, 2013, 07:17
|
Quality reduced when smoothing
|
#1 |
|
Senior Member
Francisco
Join Date: Mar 2012
Location: Spain
Posts: 273
Rep Power: 15  |
Hi you all guys,
I've done a 2D hexa mesh with quality over 0.85 (see picture 1). Then I've converted it into unstructured, I've checked quality and it is obviously the same. But when I smooth it, dor 60 iterations forcing ortogonality in wall surfaces I get a way worse quality histogram (see picture 2). The question is: Is it better to work with the non-smoothed mesh or does it worth it to use the smoothed with reduced quality? Thanks! |
|
|
|
|
| Tags |
| hexa, histogram, quality, smooth |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Smoothing options | siw | ANSYS Meshing & Geometry | 3 | August 13, 2019 07:40 |
| [ICEM] Low quality mesh | Memme | ANSYS Meshing & Geometry | 1 | May 25, 2012 02:02 |
| Getting prism to inflate into mixed tet-hex meshes | Joe | CFX | 16 | October 10, 2011 07:06 |
| [ICEM] Hex refinement negative quality afterwards | Anorky | ANSYS Meshing & Geometry | 8 | March 22, 2010 03:25 |
| Hexa smoothing (ICEM CFD 10.0) | CFDworker | CFX | 3 | November 2, 2005 10:23 |
2Likes
Threaded Mode
