[ICEM] Problems with geometry when defining boundary conditions

darazsbence · February 23, 2013, 04:08

Hello everyone,

I ran into a strange problem: i created a mesh in icem and made a cfx5 output file, but when i want to define boundary conditions in cfx-pre i cannot select any of the edges or surfaces of my geometry, only the whole body. Anybody knows the solution? Thanks

energy382 · February 23, 2013, 15:25

Quote:

Originally Posted by darazsbence

Hello everyone,

I ran into a strange problem: i created a mesh in icem and made a cfx5 output file, but when i want to define boundary conditions in cfx-pre i cannot select any of the edges or surfaces of my geometry, only the whole body. Anybody knows the solution? Thanks

what kind of mesh? hexa?

domain/insert boundary doesn't work?

flotus1 · February 24, 2013, 09:07

Did you create the individual parts in ICEM with the faces you want to select as separate boundaries?

February 23, 2013, 04:08	Problems with geometry when defining boundary conditions	#1
darazsbence New Member Darázs Bence Join Date: Feb 2013 Posts: 16 Rep Power: 13	Hello everyone, I ran into a strange problem: i created a mesh in icem and made a cfx5 output file, but when i want to define boundary conditions in cfx-pre i cannot select any of the edges or surfaces of my geometry, only the whole body. Anybody knows the solution? Thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 11:12
Some Problems about the Boundary Conditions in OpenFoam	lzgwhy	OpenFOAM Running, Solving & CFD	47	October 10, 2017 08:33
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 03:32
Problems with boundary conditions - velocity and pressure not zero	M_Flodin	FLUENT	0	April 1, 2011 09:32
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15

February 24, 2013, 09:07		#3
flotus1 Super Moderator Alex Join Date: Jun 2012 Location: Germany Posts: 3,399 Rep Power: 46	Did you create the individual parts in ICEM with the faces you want to select as separate boundaries?