|
[Sponsors] |
[Workbench] I need the help regarding desing using workbench |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 16, 2013, 02:52 |
I need the help regarding desing using workbench
|
#1 |
New Member
shiva kumar
Join Date: Mar 2013
Posts: 1
Rep Power: 0 |
I am new to CFD and I use ansys work bench for modeling a simple double pipe heat exchanger. once I modelled it and meshed it it is not able to creat the required wall and shadow for the fluid. I am not sure of the modeling technique I used is correct. Please suggest me how to create double pipe HE in workbench?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ANSYS Workbench on "Uncertified" Linux Distros | hsr | CFX | 289 | April 20, 2023 09:23 |
PEM Fuel cell module meshes. ICEM vs workbench | aarvay | FLUENT | 24 | March 2, 2020 06:50 |
[ANSYS Meshing] Workbench 13: Structured Hexa Meshes | rooftop | ANSYS Meshing & Geometry | 19 | March 31, 2016 02:33 |
Block structured hexagonal mesh vs automated tetra mesh inside Workbench for CFD | Chander | CFX | 3 | November 27, 2011 16:24 |
Workbench Transient | Omer | CFX | 0 | January 15, 2007 14:21 |