|April 23, 2013, 08:23||
how to judge the Optimization in FLUENT
Join Date: Apr 2013
Posts: 27Rep Power: 5
here is the problem.
I have already have a mesh. But,
1.when set the boundary conditions, what is the type for ground, is that 'wall'?
2. how could I optimize the aspect ratio (H/W) of a street canyon in order to avoid gust wind for pedestrians in FLUENT. 3. And how could I judge it is the Optimization ?
I am looking forward to your reply. Thanks.
|April 23, 2013, 10:59||
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Blog Entries: 23Rep Power: 21
1. ground should be wall of course.
2 and 3. not sure about the answer. take a look at other article see what you can find.
when an aerodynamic study of an airfoil in performed they usually used 10 times the cord...
New to ICEM CFD, try this document --> https://goo.gl/NEbygB
|Thread||Thread Starter||Forum||Replies||Last Post|
|How to open Icem mesh in Ansys Fluent?||emmkell||FLUENT||26||June 9, 2015 15:38|
|heat transfer with RANS wall function, over a flat plate (validation with fluent)||bruce||OpenFOAM Running, Solving & CFD||5||September 25, 2013 04:40|
|Fluent 6.3 32bit vs Fluent 12.0 64bit||ibex7||FLUENT||7||April 18, 2011 02:44|
|Fluent 12.0 is worst then Fluent 6.2||herntan||FLUENT||5||December 14, 2009 03:57|
|Master node in parallel computing only distirubtion||syadgar||FLUENT||1||September 8, 2009 16:41|