Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ICEM] Varying seeing in icem

Updated Threads

Search this Thread

Prev

Previous Post

Next Post

Next

February 17, 2017, 11:26	Varying seeing in icem	#1
skumar112 Member sunil kumar Join Date: May 2016 Posts: 80 Rep Power: 9	Hello I wanted to know if it was possible to vary the seeds on an edge without it adusting all other parallel edges. I have switched off copy parameters however it still chages all the other edges. This is one as i am meshing a HVOF gun and the inlet is 30mm and outlet 8mm and when meshing I have a obtained very poor aspect ratio.

Tags

icem, meshing 3d

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] The ICEM Guide for CFX Users	JuPa	ANSYS Meshing & Geometry	11	September 4, 2017 09:43
[ICEM] Different meshes from ICEM and GAMBIT	Mojtaba.a	ANSYS Meshing & Geometry	9	March 30, 2013 02:42
[ICEM] Meshing adjacent wall geometry and simple ICEM questions	everdimension	ANSYS Meshing & Geometry	25	June 20, 2012 04:25
varying curve mesh spacing at icem surface-mesh?	mirko_r	ANSYS Meshing & Geometry	6	January 14, 2010 13:23
Design Modeler to ICEM.....	Joe	CFX	0	January 24, 2008 03:39

All times are GMT -4. The time now is 08:31.