[devesh]

I am trying to use Ansys bladegen for generatinng the turbomachinary blade. I am not able to get any tutorials to understand the ways to use it. please suggest?

[Far]

I have some material on it. Send email id.

[devesh]

Thanks
my email id deveshks11@gmail.com.

regards.

[ranpreetbhatia]

hey guys,

I am pretty confused about both these applications (I mean Bladegen and Blademodeler). Are both of these used for modelling blades? I am trying to obtain 3d models for some blades I have designed.

I have information like chord, axial chord, span, stagger, alpha, beta, etc at 3 locations (thats root, mean and tip). But, I am not sure how to proceed with the blade modelling, all I need is the coordinates for root and tip airfoil (or may be mean as well).

Is there any way, I can get some tutorials on using bladegen or blademodeler to obtain blade profile by provide the above said parameters (thats chord, axial chord, span, stagger, alpha, beta, etc).

Any help or advice would be appreciated.

--
Regards
Ranpreet B

[hassan1201]

Help me please i can't make flow path around Axial blade and every time Error


Error: The meridional plane placement is not correct.
Context: ansFClientBMBladeDesign::Execute FlowPath1

my mail: haelsheshtawy@gmail.com

[Far]

are you using blade modeller?

[hassan1201]

yes i use blade modeler, import point and extrud the blade, and try to make path flow, Plz any help

[hassan1201]

Every time this error appears, when make flow path


Error: The meridional plane placement is not correct.
Context: ansFClientBMBladeDesign::Execute FlowPath1

[hassan1201]

Dear Sijal Ahmed Memon
Please, can you help me?

[Far]

Originally Posted by hassan1201

yes i use blade modeler, import point and extrud the blade, and try to make path flow, Plz any help

Do that in turbogrid or design modeller and then use blade editor/blade modeller tool

[hassan1201]

I had used design modeler for model the blade, after that I used blade editor to make flow path, Can i send the File to you on your email to check out?

[hassan1201]

I have airfoil made in design modeler, and i need to make flow path for it.
this figure of my blade

[Far]

you need hub and shroud surface. After that you need to do some operation, then you will be able to define flow path. You just need few more steps ...

[hassan1201]

I'd made hub, shroud, inlet, and exit lines after that defined it in flow path but
Error massage appears

[osmanpekmutlu]

Originally Posted by Far

I have some material on it. Send email id.

Dear Sijal Ahmed Memon,
Can you send these materials to my email too?
My email id is osmanpekmutlu@gmail.com.
Thanks a lot.

[Muratoglu]

Hi guys! I am new in the blade modeler and try to design a horizontal axis wind/hydro turbine. I think, designing the blade in blade modeler will be better than BladeGen. I need some documentation about blademodeler. My e-mail is: abdmuratoglu@gmail.com

Regards

[kd_adem]

Is it possible to get the material also for me. My e-mail address is: kdadem@gmail.com

Thank you very much Far and Muratoglu.

[enzo887]

please forward it to me as well

androides.gr@gmail.com

[ranpreetbhatia]

Send it to me as well, if you dont mind.

Thanks in Advance

My email address is ranpreetbhatia@gmail.com

[majidpc]

And me
m_najafpour@aim.com