 |
 |
 |
|
|
|
[Sponsors] | ||||
September 19, 2013, 08:35
|
Assigning geometry to blocking
|
#1 |
|
Senior Member
Stuart
Join Date: Jul 2009
Location: Portsmouth, England
Posts: 733
Rep Power: 25  |
Hi,
I've made a Hexa mesh but there are some problems with it. ANSYS tech support have raised a defect report and recommend putting some curves where the block edges are and making the associations. To make sure I get the geometry (points and curves) in exactly the corrects places is it possible to make a point and locate it at exactly where a vertex is? I cannot see a way to do this exactly. This is always done the other way around with blocking assigned to geometry. Thanks. |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Blocking and Symmetry | BrolY | ANSYS Meshing & Geometry | 32 | August 24, 2012 03:13 |
| [ICEM] Some hints required on blocking geometry | air_engineer_arsenal | ANSYS Meshing & Geometry | 6 | August 16, 2012 11:58 |
| [ICEM] Meshing adjacent wall geometry and simple ICEM questions | everdimension | ANSYS Meshing & Geometry | 25 | June 20, 2012 04:25 |
| [ICEM] Best way to import geometry ICEM | Cottbus | ANSYS Meshing & Geometry | 4 | June 12, 2012 09:42 |
| [ICEM] Blocking strategy | BrolY | ANSYS Meshing & Geometry | 0 | July 22, 2010 04:46 |
2Likes
Threaded Mode
