|January 25, 2014, 10:54||
Periodicity Setting ICEM for CFX
Join Date: Aug 2012
Posts: 2Rep Power: 0
I am facing problems when importing my ICEM mesh to CFX. (14.0)
In ICEM I wanted to mesh a third of a tube to take advantage of its symmetry. So I used "Global Mesh Parameters -> Set Up Periodicity" and chose the values for "Base", "Axis 0 0 1" and "Angle 120".
Computing Mesh causes no problems also regarding the Boundary Layers I added.
As usual I exported the mesh as *.cfx5 and imported it in CFX. (See Screenshot below)
As you can see the Prism Layer is not connected anymore to the Fluid Region. Also a new Region was "randomly" created in CFX-Pre named "CARTFACES".
The Symmetry Planes were reduced to the part of the Boundary Layer.
I think I miss some steps in ICEM before writing the *.cfx5 file.
Could someone please give me a hint?
Thanks in advace,
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] ICEM periodicity specification||robboflea||ANSYS Meshing & Geometry||18||November 11, 2014 15:51|
|determining displacement for added points||CFDnewbie147||OpenFOAM Native Meshers: snappyHexMesh and Others||1||October 22, 2013 09:53|
|[ICEM] How define periodicity correctly in ICEM||FJSJ||ANSYS Meshing & Geometry||15||August 28, 2013 18:03|
|Cells with t below lower limit||Purushothama||CD-adapco||2||May 31, 2010 21:58|
|Warning 097-||AB||CD-adapco||6||November 15, 2004 05:41|