|
[Sponsors] |
[DesignModeler] Valve opening geometry problem |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 24, 2014, 11:14 |
Valve opening geometry problem
|
#1 |
New Member
Darren Swales
Join Date: May 2014
Posts: 1
Rep Power: 0 |
I know this is simple, but I cannot produce what I need. I have a valve with a triangular opening that is inside a 12" valve connected to a 16" pipe. The liquid flows through this triangular opening but I cannot connect thit to the lower section.
Help appreciated!! |
|
December 26, 2014, 05:05 |
|
#2 |
Senior Member
Join Date: Mar 2014
Posts: 375
Rep Power: 13 |
you are making the triangle in the wrong plane, make it in the xz plane, and then remove the material
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
meshing problem with some complicated geometry | Parth320 | Mesh Generation & Pre-Processing | 1 | February 6, 2014 23:13 |
Gate valve flow simulations... | nikesh | FloEFD, FloWorks & FloTHERM | 5 | January 28, 2014 01:31 |
[DesignModeler] Import external geometry problem | Houman | ANSYS Meshing & Geometry | 0 | May 16, 2012 04:24 |
[ICEM] Error in opening the geometry | BrolY | ANSYS Meshing & Geometry | 1 | August 20, 2010 10:13 |
Problem importing GAMBIT mesh to Ansys geometry | David G. | CFX | 0 | June 19, 2005 06:01 |