|
[Sponsors] |
October 14, 2009, 19:02 |
convergence problem
|
#1 |
Member
Join Date: Mar 2009
Posts: 48
Rep Power: 17 |
Hi All,
My model can converge with just tet mesh but when I add the 3 layer prism mesh it can not converge. the quality of the mesh after smoothing is 0.26.Model is a bifurcation with one inlet and two similar outlets. Any suggestion will be appreciated. Thanks |
|
October 16, 2009, 15:33 |
Beauty is in the eye of the beholder...
|
#2 |
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
The correct answer to this question would depend a lot on your solver, physics, bocos, etc. But you haven't given any info.
I recommend that you ask the question again with more info and probably ask the on the solver side of CFD-Online also. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Convergence of CFX field in FSI analysis | nasdak | CFX | 2 | June 29, 2009 01:17 |
convergence problem | alexandre | FLUENT | 2 | June 14, 2007 14:31 |
convergence problem | ammi reddy | FLUENT | 1 | March 28, 2007 17:01 |
3D Fluid Flow Convergence problem | Emily | FLUENT | 2 | March 21, 2007 22:18 |
Non Convergence of 3D Heat transfer cfd problem | Balraj | Main CFD Forum | 3 | December 9, 2004 00:24 |