|
[Sponsors] |
December 6, 2009, 22:10 |
O grid creation failed
|
#1 |
New Member
Join Date: Jul 2009
Posts: 18
Rep Power: 16 |
Hi all,
i have tried to generate O grid around blocks, but failed. ICEM said that, the non-manifold boundary at node 818. How to resolve this problem ? |
|
December 10, 2009, 17:28 |
Ogrid is very Robust.
|
#2 |
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
It means you were trying to create something invalid. Perhaps that vertex is at a strange junction of blocks that doesn't allow for an ogrid direction to be determined... Or perhaps your selection of faces was not correct and created an impossible scenario.
The OGRID tool is very robust and it only fails if an ogrid is not conceivable with your given starting point and options. I can't say much more about this without seeing what is going on at node 818. If that looks fine, I would check your selected faces. |
|
December 10, 2009, 21:05 |
Thanks
|
#3 |
New Member
Join Date: Jul 2009
Posts: 18
Rep Power: 16 |
i have tried to generated another block, and an o grid is generated. It is consistent with what you said. The faces or blocks are somewhat not conceivable. Thank you again for your discussion.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transient boundary conditions | Jarrod Sinclair (Sinclair) | OpenFOAM Running, Solving & CFD | 133 | May 6, 2015 06:21 |
user subroutine error | CFDUSER | CFX | 2 | December 9, 2006 06:31 |
user defined function | cfduser | CFX | 0 | April 29, 2006 10:58 |
Combustion Convergence problems | Art Stretton | Phoenics | 5 | April 2, 2002 05:59 |
Grid check failed | Ellen | FLUENT | 5 | June 23, 2000 14:42 |